Temperature range ofhot chamberfrom +50 °C to +220 °CTemperature range ofcold chamberfrom -80 °C to +70 °CHot or cold chamber may also be utilized as individual temperature chamber.Temperature deviation in timein centre of working spaceTemperature deviation in space±0.3 K to ±1.0 K±0.5 K to ±2.0 KHeating rate of hot chamber according to IEC 60068-3-514 K/minCooling rate of cold chamberaccording to IEC 60068-3-563 K/min.Heating rate of cold chamberaccording to IEC 60068-3-52 K/min.Temperature changing tests:MIL 883 E Method 1010.7Severity D with 12 kg of IC&sdistributed over 3 shelves;measurement on test speci-mensAdaption time < 15 min.The following standards are metDIN 40 046 page 14 test Natransfer time < 10 sec.;IEC-60068-2-14 test Natransfer time < 10 sec.;MIL-STD-810 E method 503;MIL-STD-883 E method 1010.7variants ABCDFJEDEC standard JESD22-A101-ATemperature calibration values are measured at- 40 °C cold chamber+ 125 °C hot chamberPre-temperingTemperature change rates can beincreased by choice of raised orlowered temperatures in warm/coldchamber.Data for installation and operation ...Test space dimensions 470 mm wide 650 mm deep 410 mm highDimensions of installation and operation 970 mm wide (without colour- touchpanel)1290 mm wide (with colour-touchpanel)2350 mm deep2450 mm high (with cover for ball spindle)Min. possible dimensions for transport (Additional expenses possibly caused by disassembly of corresponding parts) 970 mm wide2190 mm deep (doors demounted)1985 mm highOperating conditionsAmbient temperature +10 °Cto +35 °C; max. rel. air humidity75 % r. h. max. dew point +20 °CInstallation conditionsThe max. permissible ambient temperature for storageis -25 °C to +55 °C.Note:There must not be any residual water like e.g. humidification or cooling water in the cabinet!Please protect test chamber against direct sunlight andsources of heat.